Loading... Please wait...

SKS Vented Handguard - Chinese Fits PolyTech Rifle

  • Image 1

Product Description

This helps to keep your barrel cool during rapid semi-automatic firing. It is a direct replacement for your existing SKS upper forearm, and gives your rifle an updated look. The vented upper handguard for your SKS rifle comes complete with one installation clip and screw. Works on your Chinese SKS , and may fit other varieties of the SKS rifle as well. This is not an original PolyTech Part.

Find Similar Products by Category

Write your own product review

Product Reviews

  1. Is not tall enought by about 1/8" each side length ok but "rolls" side to side 4 Star Review

    Posted by on 14th Jun 2019

    Looks Ok but also leaves large space between stock and product that is noticeable but barely adequate. Hope they stamp some bigger one on next batch that do not roll in mounts!

  2. Adequate 4 Star Review

    Posted by on 22nd Apr 2019

    Cheese graters are hard to find these days, so I am glad I was able to get one at all. That being said, the PolyTech isn't "tall" enough, and easily "rolls" inside of the ferules so that it is usually slightly canted to one side or the other (even with two retaining clips installed). It's not a huge problem, but I will be on the look out for a better fitting one.

    Just a heads up, even though these are distributed in the US, they are Chinese made, so if you really need a 922r compliant part, this ain't it.

    If, like me, you've been searching for these high and low and this is the only one you could find NIB, I'd say go for it because it's better than getting gouged on an auction site for a used one.

  3. From past reviews, this is a little tuff,be doable? 5 Star Review

    Posted by on 6th Jun 2018

    From the material and looks of this heat shield,it will look very nice. However seeing previous reviews,it not a piece of cake. Nevertheless, I up to the challenge, but as of this time,I have not installed it yet, to be continued .......

  4. Fits right, looks good 5 Star Review

    Posted by on 21st May 2018

    Though I actually didn't need it, but I'll keep it for next time. I used the handguard rivet included. Fit perfectly, squashed easily.

  5. Nice gaurd. 5 Star Review

    Posted by on 6th Feb 2018

    Product fit as described, instructions clear, just what I was looking for.

  6. Great Product 5 Star Review

    Posted by on 22nd Mar 2016

    I like the looks of my weapon after the install. The fit is a little loose on the rear of the handguard but not enough to complain about. A fix for this would be to install two tension clips, as the package only comes with one. If 2-3mm of play doesn't bother you, then I say this is a cool investment for the SKS. Also you might have to open it up a little to fit the end caps.

  7. Perfect fit and looks great on my SKS 5 Star Review

    Posted by on 4th Mar 2016

    This is a nice piece, I opened it up slightly to fit the contours of the end caps, installed the center barrel support and it stays on nice and tight, no rattling.

  8. SKS Ventilated Handguard 5 Star Review

    Posted by on 28th Feb 2016

    Arrived when they said it would, meeting the specifications of the items description. Very pleased

Add to Wish List

Click the button below to add the SKS Vented Handguard - Chinese Fits PolyTech Rifle to your wish list.

You Recently Viewed...